JUPITER TECHNICAL DOCUMENTATION

Power Up Modes

Created by Joseph Standish, Modified on Mon, 16 Nov at 3:44 PM by Joseph Standish

Pana Power Up Modes

Use Power Up Mode to control how the Pana display behaves when power is restored or when the main power switch is turned from OFF to ON.

How to access Power Up Mode

Turn on the Pana display.

Aim the Pana remote at the infrared (IR) receiver in the lower corner of the display.

Press the following buttons in order.
OK → VOL UP → OK → VOL DOWN → OK → OK

The Factory Service Menu will appear in the top-left corner of the screen. In that menu, locate Power Up Mode and select the desired setting below.

Available settings

OFF (default)  The display enters standby when power is restored. Turn it on manually when needed.

ON  The display turns on automatically when power is restored. Which input it selects depends on the Auto Input setting in the on-screen display (OSD).

Remember  The display returns to its previous power state. If it was on, it turns on automatically. If it was in standby, it stays in standby until manually turned on.

Was this article helpful?

That’s Great!

Thank you for your feedback

Sorry! We couldn't be helpful

Thank you for your feedback

Let us know how can we improve this article!

Select at least one of the reasons
CAPTCHA verification is required.

Feedback sent

We appreciate your effort and will try to fix the article